Features:
This is a Hit and Miss engine model, using an ancient structure with water cooling. The engine is mounted on a base for easy placement and operation, equipped with fuel tank lines and ignition equipment, and is ready to run. The engine will be more appreciated when working.
Startup steps:
(1) Check the engine wiring, connect the fuel tank and oil pipe, and install the battery (ignition voltage 6-7.4V).
(2) Fill the fuel tank with 95# gasoline. When securing the fuel tank, ensure that the minimum oil level in the fuel pipe is not lower than the carburetor.
(3) Check whether the screws on the model are loose and whether the throttle valve is closed. After the inspection is completed, approximately 3/4 of the cold water needs to be added to the cooling water tank.
(4) Turn on the power switch, then turn the flywheel and start the engine counterclockwise on the right side of the engine.
Notes:
(1) If there is air in the fuel pipe, please squeeze the air to fill the fuel pipe with fuel.
(2) Please be careful not to open the throttle too wide before starting. After starting the model, adjust the throttle appropriately to make the model run smoothly.
(3) If the startup is not smooth, add 2-3 drops of engine oil to the carburetor inlet and adjust the throttle appropriately.
Packing list:
Gasoline engine model*1, fuel tank*1, CDI igniter*1, Hall switch*1, instruction manual*1
